Setup guide
From the box to the water in five steps.
No glue, no screws, no clips. Cut the tubing, push it in, then anchor it on the bottom or suspend it from a dock.
Setup steps
How it goes together.
You will need 3/4" SIDR-15 polyethylene tubing, rated 125 psi, sold in 100 ft rolls at most hardware and plumbing suppliers, or supplied with orders of 9 or more. One length per hole in the trunk.
- 1
Cut the tubing
Cut one length of polyethylene tubing for each hole in the trunk, between 72 and 78 inches long. Cut both ends at a 45 degree angle.
In range: anywhere from 72″ to 78″ works. Tubing: 3/4" SIDR-15 polyethylene tubing, rated 125 psi.
- 2
Insert the limbs
Push a length of tubing into each hole in the central tube. No glue, no screws and no clips.
- 3
Anchor or suspend it
Anchor it on the bottom with its base or a cinder block tied on with wire rope, or use neither and suspend it from a dock on a lanyard. The 8ft and 10ft come as two sections: join them with the included connector first.
- 4
Deploy it
Set it in the spot you have chosen: off a dock, beside a boathouse, or along a drop-off where the bottom changes depth. Once it is in, the water warms the limbs and they relax out flat.
- 5
Let it attract fish
Within a few weeks periphyton colonizes the limbs, forage fish come to feed on it, and predators follow the forage.
Watch it come together.
The whole setup in one go, from cutting the tubing on the dock to fish on the structure.
7 steps
- 1Cut the tubingOne length per hole, 72" to 78", both ends at 45°.
- 2Insert the limbsPush a length into every hole in the trunk.
- 3Anchor or suspend itFit a base or tie on a cinder block, or suspend it from a dock. 8ft and 10ft: join the two sections first.
- 4Set it in the waterCarry it out and let it settle on the bottom.
- 5The limbs relaxThe water warms the polyethylene and the limbs lie out flat.
- 6Periphyton growsA living film takes hold on the limbs within a few weeks.
- 7Fish move inForage fish come to feed, and predators follow.
Tools
What to have on hand.
You will need
- Measuring tape or rule
- PVC cutterManual or electric
- Work gloves
Makes it easier
- Saw horsesTo support the tubing while you cut
- A pre-marked ropeMarked at 72" and 78", so you can see at a glance that a cut is in range
- Electric PVC cutterIf you are cutting a lot of tubes
Tell us about your water.
Send us the acreage, the depth and what you are trying to grow. We will tell you exactly what to sink and where. No obligation, and no upsell to something your pond does not need.
Or call 423-802-7111. You will get a person.